Description
Many manufacturer’s have implemented an increasing amount of plastic “paneling” over areas of a vehicle’s engine-bay and the clips often break or get marred-up when being removed. These clips, while not overly expensive in some cases are an ongoing headache and never look “good”.
ZSPEC has developed clip-replacement solutions leveraging our famous titanium hardware coupled with Well Nuts.
Installation instructions are straight-forward:
1) Remove OE plastic clips and push ZSPEC Well Nuts into Clip Holes on body of vehicle (under plastic panels).
2) Position panel back in place and hand-start each titanium fastener with the included washer.
3) Tighten the fasteners and enjoy. Note, each fastener needs “snugged” in place…the back-side of each well nut will “bulge” holding the panel in place.
Why ZSPEC’s Dress Up Bolts® hardware solution?
– Grade-5 Titanium Fasteners and Washers
– Completely reversible (no drilling like others)
Requires basic hand tools for installation: plastic pry tool to remove clips and #5 hex-key for installation of the ZSPEC hardware (not included).
Note – this solution works best with holes ~7.3-7.5mm in diameter. If your need varies greatly, check out our other listings with alternate sizes. This listing uses a LONGER well nut than our other M4 solution and sometimes works better if you have aftermarket carbon-fiber panels that may not sit as flush (and thus require a longer well nut which would “bulge” / grip more when tightened).
Common (known) fitments/use for this size: Nissan 350z/370z/RZ34, Infiniti G/Q service panel covers and radiator air-guides. Note, 350z front “bumper” clips require using our M5 replacement solution…and 300zx Z32 “Cowls” will use our M3.
Explore more from our collection.
Reviews
There are no reviews yet.